1. Home
  2. Audio & Subtitles
  3. Normalize Audio Volume

Normalize Audio Volume

Raise quiet audio or even out uneven volume to a consistent loudness.

For every format and option in one place, use Audio Editor & Converter →

Runs in your browser · No upload
Pick a mode to see the current loudness and the gain that will be applied. Speed, pitch and reverse can be stacked from "Add a step" below.
Open an audio file to see its waveform, then stack steps below and save once.
Your file is processed only in this browser and never sent to a server.

How to use

  1. Drop or click to open an MP3, WAV, M4A or OGG file. This page opens with the Volume (normalize / gain) step already added.
  2. Pick a mode. Loudness normalize (LUFS) matches perceived loudness, Peak normalize brings the loudest sound to a target (default −1 dBFS), and Fixed dB raises or lowers by a set amount.
  3. Below the settings you see the current loudness and peak, and the gain (dB) that will be applied. If a warning appears, lower the target.
  4. Listen to Original and Result in turn, then save.

How the modes differ

Mode Based on Use it when
Loudness normalize Integrated loudness (LUFS) Matching several files, podcasts or video voice
Peak normalize Largest sample (dBFS) Raising a quiet recording as far as it can go without clipping
Fixed dB A value you choose A small boost or cut (+6 dB is about double)

Normalizing a signal with peak 0.5 to −1 dBFS applies +5.02 dB. LUFS follows ITU-R BS.1770: a stereo 1 kHz sine at −20 dBFS measures −20.0 LUFS, and normalizing it to −14 LUFS applies +5.99 dB.

Choosing a target

Targets differ by service. −14 LUFS is commonly quoted for streaming, −16 for podcasts and −23 for broadcast (EBU R128), but policies change, so check where you will upload. A file that is quiet overall may need so much gain that the peak passes −1 dBFS. A simple hard limiter then clips the excess and shows a warning. It is not a true-peak limiter, so it can sound harsh; lowering the target is the safer fix.

A completely silent file has no measurable loudness, so no gain is applied.

Speed, pitch and reverse

From Add a step in the same workbench you can also stack speed, pitch and reverse.

  • Speed changes length only, from 0.5× to 2×, keeping the pitch (WSOLA). A 2-second 1 kHz sine at 2× becomes 1.0 s and stays at 1,000 Hz.
  • Pitch is −12 to +12 semitones and keeps the length. 500 Hz raised by 12 semitones becomes about 1,000 Hz.
  • Change speed and pitch together acts like speeding up a tape: both change at once.
  • Reverse plays the sound from end to start.

Steps run from the top, so changing speed first and then matching the volume is usually the better order.

Your file is processed only in this browser and never sent to a server.

Can't find the tool you need?

Tell us what you want to do. We build the most requested tools first.